
Brashmaster
Brashmaster is BLAMMO! Electronics' clone of the Maestro Brassmaster, the 1972 octave-up fuzz that bass players took up first and guitarists discovered later. BLAMMO! describes it as a faithful copy with no component values altered, using the same 2N3392 and 2N5308 transistor types as the original and a properly rated transformer. The transformer is central to the sound. In octave fuzz circuits of this kind it splits the signal into two opposite phases that are then rectified, folding the waveform over so that it sounds an octave above the note played. The outcome is a raw, brassy fuzz with a pronounced upper octave, the sound of an original that is now rare. One practical problem with the Brassmaster is that every control on it changes the output level, so finding a tone and finding a usable volume pull against each other. BLAMMO!'s one modification deals with exactly that: a master volume has been added at the very end of the circuit. The original controls can be set for the sound, and the overall level adjusted afterwards without disturbing it. Everything else is about fitting a large vintage unit onto a modern pedalboard. The Brashmaster is built with through-hole parts, Panasonic film capacitors and Nichicon electrolytics, in a compact enclosure with top-mounted jacks. Its footswitch is a click-free soft switch with true bypass that also works momentarily when held down, and the pedal remembers whether it was on or off when power is removed. Each one is made by hand in Portland, Oregon.



