
ER-2 Block 3 Uni-Vibe
The throbbing, watery swirl of the classic Uni-Vibe has soundtracked a lot of records, and the ER-2 Block 3 is ThorpyFX's analog attempt to cover that territory in a much smaller package. The maker says the circuit was designed from the ground up rather than copied, and it describes the pedal as shrunk from the original while still aiming for the modulation heard on classic Uni-Vibe recordings. Block 3 is an evolution of the ER-2 Block 2, and the headline change is an extra switch: a toggle that selects in-phase or out-of-phase operation, altering the depth of both the vibe and chorus sounds. Four knobs run the show. Intensity and Speed set the character and rate of the sweep, Volume sets the output level, and Offset changes how the internal LFO ramps up. Two footswitches handle ON/OFF and VIB/CHO, so you can flip between the vibrato and chorus flavors on the fly. Power is a standard 9V center-negative supply drawing 50mA, and the jacks are top-mounted. The enclosure is laser-cut anodised aluminium with a blue and black sparkle powder-coated base, recessed knobs and a sloped front panel, which gives it a distinctive look on a board. The pedal measures 100 by 125 by 53 millimeters, and because engaging it gives a fully wet signal, it is designed to replace your dry tone rather than sit beside it.



