
PCH Active Direct Interface
PCH is Strymon's stereo active direct interface, and it has a second job that most DI boxes can't do: it is also a headphone amplifier. It is designed to sit at the very end of a pedalboard and carry the signal to a PA, a recording interface or a pair of full-range powered speakers, while letting the player hear exactly what is being sent. That matters because more players now run without an amp on stage, and a board full of drives, modellers and stereo effects can put out far hotter levels than an ordinary direct box expects. PCH takes a standard 9-volt pedal supply and converts it internally to 24 volts, using a single-channel version of Strymon's own Ojai power supply, which gives it enough headroom that Strymon describes it as nearly impossible to clip. The company quotes very low noise and a frequency response that stays flat well beyond the range of hearing, so the box adds no colour of its own. The two channels work in stereo or as two separate mono paths. The balanced XLR outputs can be switched between mic and line level and have a ground lift for chasing out hum, and the thru outputs have a switchable mono sum. The headphone amplifier has its own level control and enough power to drive high-impedance studio headphones cleanly, which turns the whole board into a silent practice rig. Strymon is best known for digital reverbs and delays, but PCH is an analog design, and the company pitches it at anyone with a pedalboard, not only guitarists.



