
Microphonic Fuzz
Most fuzz pedals try to eliminate unwanted noise. The Microphonic Fuzz invites it in. Behind the grille on the bottom end panel sits a small microphone that listens to the room, including your amp, and feeds what it hears back through the signal, so the pedal can bloom into feedback that depends on the room and your amp. The fuzz itself is an analog Rainger FX design that is high-gain without being especially saggy or gated. There is no gain control, since you set the amount of fuzz with your guitar's volume knob. A three-way tone switch picks between a mid-heavy voice with no tone circuit, an ultra-scooped bass-and-treble setting, and a full-range sound that combines the two, while a Hi Freq knob adjusts overall treble. Two filters, high-pass and low-pass, steer the feedback towards particular frequency regions rather than letting it run wild. The microphone side has its own controls: a volume knob, plus a Rate knob that adds square-wave tremolo to the mic circuit only, with white LEDs that light as the mic feeds back and can flash with the tremolo. A shallow flanging effect on the mic signal cannot be switched off. The mic can be switched in or out, there is an XLR socket for an external microphone, and the pedal runs from a battery or a power supply. The maker warns that the open mic can produce very loud feedback.



