
Fission Drive
Fission Drive is the first commercial pedal from Nuclear Audio, and it takes an unusual route to overdrive. The signal is split into a low band and a high band at a crossover point chosen by the player, each band is driven separately, and the two are then recombined. The reasoning is straightforward. When a full-range signal hits a single clipping stage, the low notes tend to turn muddy and the top end brittle. Driving the bands independently lets a player keep the lows tight while the highs saturate, or the reverse, and the pedal is offered for bass as well as guitar. Its range is described as running from subtle breakup to thick fuzz. The panel is laid out in four sections. Low Freq and High Freq each have Gain and Level knobs and a toggle for low or high gain. Split Freq has a single knob with a range switch, and the panel markings run from about 50 to 900 Hz in the low range and 300 Hz to 5 kHz in the high one. The Output section has Volume, Tone and a Notch/Flat switch. In Flat the pedal corrects the phase so that the bands sum evenly at the crossover, while Notch turns that correction off and leaves a dip around the split frequency, a tone-shaping option in its own right. Each band also has its own send and return, so different effects can be placed on the lows and the highs, or the two sends can feed separate amplifiers while the main output carries the recombined signal. Power is 9 volts DC, centre negative.