
Sunset Bass Amplifier Simulator
Sunset is a bass amplifier simulator from the Canadian builder MayFly Audio, designed to take the place of an amp on stage or in the studio. It is fully analogue, which means zero latency, and it is intended to go straight into a PA or a recording setup while still feeling like an amplifier under the fingers. The amp character comes from the Gain control. At low settings there is little compression. Turn it up and the circuit behaves more like a tube amp, compressing and adding harmonics when you dig in, which is where the growl comes from. A Master volume sets the overall level, so the amount of drive and the output can be balanced separately. The equaliser is unusually thorough for a pedal, with five bands tuned specifically for bass guitar. Bass and Treble handle the broad strokes. The midrange is a true parametric, with separate frequency and level controls and twelve decibels of boost or cut, so you can find the exact spot that makes a bass honk or disappear and deal with it. Active Presence and Resonance controls then reach out to the extremes, shaping the very top and the very bottom of the range. Connections are simple: a high-impedance quarter-inch input that suits both passive and active pickups, plus quarter-inch and balanced XLR outputs, so the pedal doubles as an active direct box. It runs on a 9-volt supply and has a full bypass. MayFly notes that keyboards and synthesizers also sound good through it. For bassists going ampless, it offers real knobs, a serious EQ and no menus.