
Greathammer Bass Driver
Most bass overdrives either scrub away the low end or bolt a clean blend onto a distortion circuit. The Greathammer from Electronic Audio Experiments goes after something heavier: a solid-state driver and preamp for bass that is meant to stay huge in the lows even when the gain is cranked. It is also happy in front of a guitar amp, where the same weight turns into a thick, slightly gnarly wall. The circuit starts from the sound of a 1970s Canadian solid-state bass amp, although several blocks were redesigned from scratch and the low-frequency extension goes deeper than the inspiration. There is no traditional clean blend. Gain reaches roughly 50 dB at its limit, so the range runs from nearly clean to properly extreme. Four knobs and a toggle do the shaping. Level sets output, and Gain sets the drive. Bass is a shelf placed after the clipping that can add up to 14 dB at 100 Hz and below. Attack acts before the gain stage on everything above 1 kHz, changing how the pedal reacts to pick snap. The three-position Notch switch handles mid cut: flat, moderate, or full. Practical touches include silent electronic bypass behind a high-headroom op amp buffer, reverse polarity protection, and tolerance for over-voltage. It runs on a 9V supply and takes no battery. For bassists who like their drive loud and rounded, it is a distinctive, low-end-first option.



