Guitar
Pedal
Finder

ExploreBrandsGuidesPedalboardsFAQ
  1. Home
  2. /
  3. DPE Pedals
  4. /
  5. DC-30 EF86 Tube Preamp
DPE Pedals DC-30 EF86 Tube Preamp
DPE Pedals

DC-30 EF86 Tube Preamp

DC-30 EF86 Tube Preamp is DPE Pedals' hand-wired valve preamp in pedal form, built around a single EF86 (6267) pentode and modelled on the hand-wired EF86 preamps of the early 1990s. Rather than starving the tube at pedalboard voltage, DPE runs it at more than 250 volts DC, stepped up inside the box from an ordinary 9-volt supply, so the valve behaves much as it would in an amplifier. The EF86 is a pentode, a tube type that delivers far more gain from one stage than the usual twin triode, and that is a large part of why amps built on it sound thick and break up readily. DPE arranges its circuit as two footswitchable stages, clean and dirty, each with its own Gain and Volume, so the pedal works like a two-channel front end. A pre-gain Tone control shapes what reaches the tube, a four-position Depth rotary lets progressively more low end through the circuit, a Cut switch trims the highs, and Master sets the overall output. DPE's stated aim is to turn another amplifier into a DC-30-style amp. The maker says the pedal sounds best when it takes the place of the host amp's own preamp and feeds the power section directly, though it can also sit in front of an ordinary input. Each unit is built, wired and tested one at a time, and the enclosure colour and the tube are chosen at order, including new-old-stock EF86s when DPE can source them, with a warning that old stock may add noise. It needs 9 volts DC, centre negative, at 500 mA or more, ideally from an isolated supply.

Categories

OverdrivePreamp
Buy on AmazonView on Reverb