Guitar
Pedal
Finder

ExploreBrandsGuidesPedalboardsFAQ
  1. Home
  2. /
  3. Dirty Sock Effects
  4. /
  5. Dot / Matrix
Dirty Sock Effects Dot / Matrix
Dirty Sock Effects

Dot / Matrix

Dot / Matrix is Dirty Sock Effects' envelope-controlled square-wave tremolo, built around a lo-fi analog sample-and-hold chip that is run well beyond its intended limits. Depending on one knob it behaves as three different effects, a hard on-off tremolo, a bit-crusher and something close to a ring modulator, and it can move between them in response to how hard the strings are played. Rate is that knob. It sets how often the chip samples the signal. At low settings the samples are slow enough to be heard as separate chops, which is the tremolo. As the rate rises the sampling moves into the audio range, and the steps become first the grainy texture of sample-rate reduction and then the clanging tones of ring modulation. The envelope section puts Rate under the control of playing dynamics. Sensitivity sets how strongly the detector reacts, from slight movement to sweeping the whole range, and a Hi/Lo switch sets the direction: in Lo, harder picking speeds the effect up from a minimum set by the Rate knob, and in Hi it slows the effect down from a maximum. An On/Off switch removes the envelope altogether for a fixed rate. A rear expression jack takes over from the Rate knob when a pedal is connected, and it works alongside the envelope. Three more knobs fit the sound into a signal chain. Mix runs from fully dry to fully wet, Tone is a treble cut that acts on the wet signal only, softening the harshest artefacts, and Volume trims the output. The pedal is true bypass and runs on a 9-volt supply.

Categories

TremoloRing ModulatorBitcrusher
Buy on AmazonView on Reverb