
The Glass Drive
Glass Drive is really two pedals sharing one enclosure. One channel is an octave-up harmonic distortion, the other is an octave-down voice, and you can run either alone or stack both for a thick, synthy fuzz that sounds unlike most overdrives. The octave-up side adds shimmery harmonic edge on top of the note. The octave-down side has a toggle that picks either one or two octaves below, adding a growling sub layer that is especially dramatic on single-note lines. Footswitching the channels independently lets you move from plain octave-up crunch to a huge combined wall of sound in a single stomp. Four main controls handle the blend. Blend mixes the two channels through an active mixer stage, Filter shapes the tone, and Smash is the master output level. A Focus control trims each effect path and lets you fold in clean signal, which helps keep the pitch from turning into pure mush when you play chords. There is also a toggle on the octave-up channel for switching it on and off. The build is a serious one. It uses analog octave circuits, with a single digital chip in the mix, a buffered input and buffered bypass, and a custom board that keeps the input, output and power sections separate from the effect circuits. Axewerx assembles each unit by hand in Canada and tests it before it leaves the shop. It runs on nine volts, center negative. Among octave-fuzz hybrids, it is a bold and slightly unhinged choice.